Getting The Best Swim Spa Cover

Swim Spas represent special challenges when it pertains to covering them.
We can all concur that the swim spa has to be covered when not in use for all the same factors a hot tub needs a cover. The obstacle is that because of the length of the swim spa and the height of the sides, getting rid of and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting event in life. You’re anticipating the exercise you’ll obtain from using it. Possibly you’re a little relieved to have finally selected from the different models you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Usually, the cover that comes home with your brand-new purchase will be a 4 section stiff foam filled cover that will divide in the center and go off both ends.
No big deal.
Up until it starts to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Built in obsolescence because as quickly as it is put in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The molecules of steam are really little as they increase from the water surface. They make their method into the little fractures and crevices in the foam.

Then as the steam cools it forms back into a liquid and ends up being caught in the cover.
It takes place gradually and on a Swim Spa Cover which is made from specific sections, at differing speeds. So ultimately you’ll see one or two of the areas are actually getting heavy. The bar lifters on the ends of the swim spa aren’t much aid since you still need to lift that heavy cover back up onto the spa which is a lot higher than a regular spa.
This is why SpaCap.com created a different design for their Swim Spa Covers
Instead of using several foam panels to develop Swim Spa Covers that will ultimately end up in some garbage dump, they created one that uses air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be damaged by snow or hail.
Covered with Sunbrella Marine material, these covers will not fade, or fall apart at the seams either. So if you own a swim spa, and you plan to keep using it everyday, SpaCap.com has the cover for it.
If you’re not prepared to purchase today, bookmark this website so you can find it once again when you’re ready!

Leave a Reply

Your email address will not be published. Required fields are marked *